HP 6600 Security Configuration Manual page 114

For information about the RADIUS commands used on the Router in this example, see Security
Command Reference.
3. Assign an IP address for each interface on the Router. (Details not shown.)
4. Configure user accounts for the 802.1X users on the Router:
# Add a local user with the username localuser, and password localpass in plaintext. (Make sure
the username and password are the same as those configured on the RADIUS server.)
<Router> system-view
[Router] local-user localuser
[Router-luser-localuser] service-type lan-access
[Router-luser-localuser] password simple localpass
# Configure the idle cut function to log off any online user that has been idled for 20 minutes.
[Router-luser-localuser] authorization-attribute idle-cut 20
[Router-luser-localuser] quit
5. Configure a RADIUS scheme:
# Create the RADIUS scheme radius1 and enter its view.
[Router] radius scheme radius1
# Specify the IP addresses of the primary authentication and accounting RADIUS servers.
[Router-radius-radius1] primary authentication 10.1.1.1
[Router-radius-radius1] primary accounting 10.1.1.1
# Configure the IP addresses of the secondary authentication and accounting RADIUS servers.
[Router-radius-radius1] secondary authentication 10.1.1.2
[Router-radius-radius1] secondary accounting 10.1.1.2
# Specify the shared key between the Router and the authentication server.
[Router-radius-radius1] key authentication name
# Specify the shared key between the Router and the accounting server.
[Router-radius-radius1] key accounting money
# Exclude the ISP domain name from the username sent to the RADIUS servers.
[Router-radius-radius1] user-name-format without-domain
[Router-radius-radius1] quit
NOTE:
The Router must use the same username format as the RADIUS server. If the RADIUS server includes the ISP
domain name in the username, so must the Router.
6. Configure the ISP domain:
# Create the ISP domain aabbcc.net and enter its view.
[Router] domain aabbcc.net
# Apply the RADIUS scheme radius1 to the ISP domain, and specify local authentication as the
secondary authentication method.
[Router-isp-aabbcc.net] authentication lan-access radius-scheme radius1 local
[Router-isp-aabbcc.net] authorization lan-access radius-scheme radius1 local
[Router-isp-aabbcc.net] accounting lan-access radius-scheme radius1 local
# Set the maximum number of concurrent users in the domain to 30.
[Router-isp-aabbcc.net] access-limit enable 30
100