HP 6600 Security Configuration Manual page 179

Figure 67 Device list
b. On the port group configuration page, click Add to enter the page shown in
c. Enter the port group name.
d. Select the configured IP address group.
The IP address used by the user to access the network must be within this IP address group.
e. Use the default settings for other parameters.
f. Click OK.
Figure 68 Adding a port group
5. Select User Access Manager > Service Parameters > Validate from the navigation tree to validate
the configurations.
Configuring Router A
1. Configure VRRP:
# Create VRRP group 1, and configure the virtual IP address of the VRRP group 1 as 9.9.1.1.
<RouterA> system-view
[RouterA] interface gigabitethernet 0/0/1
[RouterA–GigabitEthernet0/0/1] vrrp vrid 1 virtual-ip 9.9.1.1
# Set the priority of GigabitEthernet0/0/1 in VRRP group 1 to 200.
[RouterA–GigabitEthernet0/0/1] vrrp vrid 1 priority 200
# On GigabitEthernet 0/0/1, configure the interface to be tracked as GigabitEthernet 0/0/2 and
reduce the priority of GigabitEthernet 0/0/1 in VRRP group 1 by 150 when the interface state of
GigabitEthernet 0/0/2 becomes Down or Removed.
[RouterA–GigabitEthernet0/0/1] vrrp vrid 1 track interface GigabitEthernet 0/0/2
reduced 150
[RouterA–GigabitEthernet0/0/1] quit
# Create VRRP group 2, and configure the virtual IP address of the VRRP group 2 as 192.168.0.1.
[RouterA] interface GigabitEthernet 0/0/2
165
Figure 68.