Publickey Authentication Enabled Stelnet Server Configuration Example - HP FlexFabric 5930 Series Security Configuration Manual

Figure 25 Specifying the host name (or IP address)
c. Click Open to connect to the server.
If the connection is successfully established, the system asks you to enter the username and
password. After entering the username (client001 in this example) and password (aabbcc in this
example), you can enter the CLI of the server.
Publickey authentication enabled Stelnet server configuration
example
Network requirements
As shown in
and are assigned the user role network-admin for configuration management. The switch acts as the
Stelnet server and uses publickey authentication and the RSA public key algorithm.
Figure 26 Network diagram
Stelnet client
192.168.1.56/24
Host
Figure 26, you can log in to the switch through the Stelnet client (SSH2) that runs on the host
Vlan-int2
192.168.1.40/24
Stelnet server
Switch
119