Omron CS1G/H-CPUxx-EV1 Programming Manual page 326

Serial Communications
Type Command
code
File Memory 22 01
22 02
22 03
22 04
22 05
22 07
22 08
22 0A
22 0B
22 0C
22 15
Forced Status 23 01
23 02
290
Name
FILE NAME READ
SINGLE FILE READ
SINGLE FILE WRITE
FILE MEMORY FORMAT
FILE DELETE
FILE COPY
FILE NAME CHANGE
I/O MEMORY AREA FILE
TRANSFER
PARAMETER AREA FILE
TRANSFER
PROGRAM AREA FILE TRANS-
FER
CREATE/DELETE DIRECTORY Creates or deletes a directory.
FORCED SET/RESET
FORCED SET/RESET CANCEL Cancels the forced status of all force-set and force-reset
Message Communications Functions
The FINS commands listed in the table above can also be transmitted through
the network from other PLCs to the CPU Unit. Observe the following points
when transmitting FINS commands through the network.
• CPU Bus Units (such as Controller Link Units or Ethernet Units) must be
mounted in the local PLC and destination PLC to transmit FINS com-
mands.
• FINS commands are issued with CMND(490) from the CPU Unit's pro-
gram.
• FINS commands can be transmitted across up to eight networks for the
CS/CJ-series CPU Units Ver. 2.0 or later and across up to three networks
for other CPU Units. The networks can be the same type or different
types.
Serial Communications Unit
Refer to the CPU Bus Unit's Operation Manual for more details on the mes-
sage communications functions.
Function
Reads the file memory's file information.
Reads the specified amount of data from the specified
point in a file.
Writes the specified amount of data from the specified
point in a file.
Formats file memory.
Deletes the specified files from file memory.
Copies a file within file memory or between two file
memory devices in a system.
Changes a file name.
Transfers or compares data between the I/O memory
area and file memory.
Transfers or compares data between the parameter area
and file memory.
Transfers or compares data between the program area
and file memory.
Force-sets, force-resets, or clears the forced status of
the specified bits.
bits.
Serial Communications Unit
FINS command
Section 6-3
CMND