Omron CS1G/H-CPUxx-EV1 Programming Manual page 280

Manipulating Files
Procedure
1,2,3...
244
Unit/Board
Customizable
Counter Units
Motion Control
Units
Position Control
Units
Note Data from the Units and Boards listed above will be automatically backed up
for the simple backup operation. There is no setting available to include or
exclude them. If a Programming Console is used, however, operations are
supported individually for the user program area, parameter area, and I/O
memory areas. Refer to the Programming Console Operation Manual (W314)
for details.
The procedure for the simple backup operation is the same regardless of
whether or not data is being backed up from specific Units and Boards
(including writing, reading, and comparing).
■ Backing Up Data
1. Turn ON pin 7 on the CPU Unit's DIP switch.
2. Press and hold the Memory Card Power Supply Switch for three seconds.
The backup data for the Units and Boards will be created in a file and
stored in the Memory Card with the other backup data.
DeviceNet Unit or other
specific Unit/Board
Simple
backup data
When the Power Supply Switch is pressed, the MCPWR Indicator will flash
once, light during the write operation, and then go OFF if the write is com-
pleted normally.
Model numbers Data backed up for
simple backup when
used with CS1-H/CJ1-H
CS1W-HIO01-V1 • User program
CS1W-HCP22-V1
• General-purpose read-
CS1W-HCA22-V1
only DM
CS1W-HCA12-V1
• Unit function setting area
• Information on expan-
sion instructions
• Ladder library
CS1W-MCH71 • Positioning data
• System parameters
CS1W-MC221-V1
CS1W-MC421-V1
• G language programs
CS1W- • Axis parameters
NC113/133/213/2
• Sequence data
33/413/433
• Speed data
Ver. 2.0 or later
• Acceleration/decelera-
CJ1W-
tion time data
NC113/133/213/2
• Dual timer data
33/413/433
• Zone data
Ver. 2.0 or later
Memory Card power
supply switch
CPU Unit
All data
Memory Card
Backup
Section 5-2
Data capacity
used in Memory
Card for simple
CPU Unit backup
64 Kbytes
8,192 Kbytes
142 Kbytes
7 Kbytes