Omron CS1G/H-CPUxx-EV1 Programming Manual page 234

File Memory
Type 1
Name
Program AUTOEXEC
File
Parameter AUTOEXEC
Area File
Data File AUTOEXEC
ATEXECDM .IOM
ATEXECE@
198
Transferring with a Parameter Area File
Extension Description
.OBJ Entire user program
.STD PLC Setup, registered
I/O table, routing tables,
CPU Bus Unit settings
etc.
.IOM I/O memory data
(Contains the specified
number of words of data
beginning at D20000.)
I/O memory data
(Contains the specified
number of words of data
beginning at D00000.)
.IOM
EM Area data (bank @)
(Contains the specified
number of words of data
beginning at
E@_00000.)
Explanation
• The file does not have to be on the
Memory Card even when automatic
transfer at startup is specified.
• All cyclic and interrupt task programs
as well as task data for one CPU Unit.
• Transfer will not be possible unless the
Memory Card also contains a parame-
ter area file (AUTOEXEC.STD).
The file must be on the Memory Card
when automatic transfer at startup is
3 specified.
,
Includes all initial settings for one CPU
Unit.
The user does not have to distinguish
parameter data in the file by type.
Initial setting data will automatically be
stored at specific locations in the CPU
Unit at startup
The parameter area file will not be trans-
ferred if the Memory Card contains a pro-
gram file called REPLACE.OBJ.
•
Store DM data beginning at D20000 in
a file named AUTOEXEC.IOM.
•
At startup, all of the data in the file will
be transferred to the DM Area begin-
ning at D20000.
•
This file does not have to be on the
Memory Card when the automatic
transfer at startup function is being
used.
2 •
Store DM data beginning at D00000 in
a file named ATEXECDM.IOM.
•
At startup, all of the data in the file will
be transferred to the DM Area begin-
ning at D00000.
•
This file does not have to be on the
Memory Card when the automatic
transfer at startup function is being
used.
Note
The data in this file has higher pri-
ority if it overlaps the DM data
contained in AUTOEXEC.IOM.
• Store data for EM bank @ beginning at
2
E@_00000 in a file named ATEX-
ECE@.IOM. The maximum bank num-
ber depends upon the model of CPU
Unit being used.
• At startup, all of the data in the file will
be transferred to EM bank @ beginning
at E@_00000.
• This file does not have to be on the
Memory Card when the automatic
transfer at startup function is being
used.
Section 5-1
File
Required
Required
---
---
---