Configuring A Dynamic Aggregation Group - HP 3600 v2 series Configuration Manual

To do...
Create a Layer 3 aggregate
interface and enter Layer 3
aggregate interface view
Exit to system view
Enter Layer 3 Ethernet
interface view
Assign the Ethernet interface
to the aggregation group
Assign the port an
aggregation priority

Configuring a dynamic aggregation group

NOTE:
To guarantee a successful dynamic aggregation, be sure that the peer ports of the ports aggregated at one
end are also aggregated. The two ends can automatically negotiate the aggregation state of each member
port.
Configuring a Layer 2 dynamic aggregation group
Follow these steps to configure a Layer 2 dynamic aggregation group:
To do...
Enter system view
Set the system LACP
priority
Create a Layer 2
aggregate interface and
enter Layer 2 aggregate
interface view
Configure the
aggregation group to
work in dynamic
aggregation mode
Exit to system view
Use the command...
interface
route-aggregation
interface-number
quit
interface interface-type
interface-number
port link-aggregation
group number
link-aggregation
port-priority port-priority
Use the command...
system-view
lacp system-priority
system-priority
interface
bridge-aggregation
interface-number
link-aggregation mode
dynamic
quit
40
Remarks
Required
When you create a Layer 3 aggregate interface,
the system automatically creates a Layer 3 static
aggregation group numbered the same.
—
Required
Repeat these two steps to assign more Layer 3
Ethernet interfaces to the aggregation group.
Optional
By default, the aggregation priority of a port is
32768.
Changing the aggregation priority of a port might
affect the aggregation state of the ports in the
static aggregation group.
Remarks
—
Optional
By default, the system LACP priority is 32768.
Changing the system LACP priority might affect the
aggregation state of the ports in a dynamic aggregation
group.
Required
When you create a Layer 2 aggregate interface, the
system automatically creates a Layer 2 static
aggregation group numbered the same.
Required
By default, an aggregation group works in static
aggregation mode.
—