To do...
Set the LACP timeout
interval on the port to the
short timeout interval (1
second)
Configuring an aggregate interface
NOTE:
Most of the configurations that can be performed on Layer 2 or Layer 3 Ethernet interfaces can also be
performed on Layer 2 or Layer 3 aggregate interfaces.
Configuring the description of an aggregate interface
You can configure the description of an aggregate interface for administration purposes such as
describing the purpose of the interface.
Follow these steps to configure the description of an aggregate interface:
To do...
Enter system view
Enter
aggregat
e interface
view
Configure the description of the
aggregate interface
Configuring the MTU of a Layer 3 aggregate interface
Maximum transmission unit (MTU) of an interface affects IP packets fragmentation and reassembly on the
interface.
Follow these steps to change the MTU of a Layer 3 aggregate interface:
To do...
Enter system view
Enter Layer 3 aggregate interface view
Configure the MTU of the Layer 3
aggregate interface
Use the command...
lacp period short
Use the command...
system-view
Enter Layer 2
interface bridge-aggregation
aggregate
interface-number
interface view
Enter Layer 3
interface route-aggregation
aggregate
interface-number
interface view
description text
Remarks
Optional
By default, the LACP timeout interval on a port is
the long timeout interval (30 seconds).
Use the command...
system-view
interface route-aggregation
interface-number
mtu size
42
Remarks
—
Required
Use either command.
Optional
By default, the description of an
interface is in the format of
interface-name Interface, such as
Bridge-Aggregation1 Interface.
Remarks
—
—
Optional
1500 bytes by default.