Layer 3 Dynamic Aggregation Configuration Example - HP 3600 v2 series Configuration Manual

# Display the global link-aggregation load-sharing criteria on Device A.
[DeviceA] display link-aggregation load-sharing mode
Link-Aggregation Load-Sharing Mode:
destination-ip address,
The output shows that the global link-aggregation load-sharing criteria are the source and destination IP
addresses of packets.

Layer 3 dynamic aggregation configuration example

Network requirements
As shown in
Device A and Device B are connected by their Layer 3 Ethernet interfaces Ethernet 1/0/1 through
•
Ethernet 1/0/3.
Configure a Layer 3 dynamic aggregation group on Device A and Device B respectively and
•
configure IP addresses and subnet masks for the corresponding Layer 3 aggregate interfaces.
Enable traffic to be load-shared across aggregation group member ports based on source and
•
destination IP addresses.
Figure 15 Network diagram
Configuration procedure
Configure Device A.
1.
# Create Layer 3 aggregate interface Route-Aggregation 1, configure the link aggregation mode as
dynamic, and configure an IP address and subnet mask for the aggregate interface.
<DeviceA> system-view
[DeviceA] interface route-aggregation 1
[DeviceA-Route-Aggregation1] link-aggregation mode dynamic
[DeviceA-Route-Aggregation1] ip address 192.168.1.1 24
[DeviceA-Route-Aggregation1] quit
# Assign Layer 3 Ethernet interfaces Ethernet 1/0/1 through Ethernet 1/0/3 to aggregation group 1.
[DeviceA] interface ethernet 1/0/1
[DeviceA-Ethernet1/0/1] port link-aggregation group 1
[DeviceA-Ethernet1/0/1] quit
[DeviceA] interface ethernet 1/0/2
[DeviceA-Ethernet1/0/2] port link-aggregation group 1
[DeviceA-Ethernet1/0/2] quit
[DeviceA] interface ethernet 1/0/3
[DeviceA-Ethernet1/0/3] port link-aggregation group 1
[DeviceA-Ethernet1/0/3] quit
# Configure Device A to use the source and destination IP addresses of packets as the global
link-aggregation load-sharing criteria.
source-ip address
Figure 15:
54