To do...
Enter system view
Enter VLAN view
Configure the VLAN as a
super VLAN
Associate the super VLAN
with the specified sub-VLANs
NOTE:
When dynamic MAC-based VLAN assignment is enabled on a port, you cannot configure VLANs of the
MAC address-to-VLAN entries as super VLANs.
Configure a VLAN interface for the super VLAN
Follow these steps to configure a VLAN interface for the super VLAN:
To do...
Enter system view
Create a VLAN interface, and
enter VLAN interface view
Configure the IP address of
the VLAN interface
Enable local proxy ARP
Enable local proxy ND
Use the command...
system-view
vlan vlan-id
supervlan
subvlan vlan-list
Use the command...
system-view
interface vlan-interface vlan-interface-id
ip address ip-address { mask |
mask-length } [ sub ]
ipv6 address { ipv6-address
{ prefix-length | link-local } |
ipv6-address/prefix-length [ anycast |
eui-64 ] | auto [ link-local ] }
local-proxy-arp enable
local-proxy-nd enable
142
Remarks
—
Required
If the specified VLAN does not exist, this command
creates the VLAN first, and then enters VLAN view.
Required
Not configured by default.
Required
VLANs specified by vlan-list must be the
sub-VLANs configured earlier.
Remarks
—
Required
The value of vlan-interface-id must
be the ID of the super VLAN.
Required
Use either command.
By default, the IP address of a
VLAN interface is not configured.
Required
Use either command.
Disabled by default.