Configuring Inner Vlan Id Substitution - HP 3600 v2 series Configuration Manual

NOTE:
On the 3600 v2 Switch Series, if you have not used either of the two methods previously mentioned to
•
mark the 802.1p priority of the outer VLAN tag, a basic QinQ-enabled or selective QinQ-enabled port
which is configured to trust packet priority copies the 802.1p priority in the inner VLAN tag to the outer
VLAN tag when tagging a packet; a basic QinQ-enabled or selective QinQ-enabled port which is
configured to trust port priority uses the priority of the receiving port (0 by default) as the 802.1p priority
in the outer VLAN tag.
• For more information about priority trust mode, see

Configuring inner VLAN ID substitution

Basic QinQ does not change the inner VLAN ID when tagging the customer VLAN frame with an outer
VLAN tag. Selective QinQ can change the inner VLAN ID according to the inner VLAN ID substitution
function you configured.
NOTE:
Configure inner VLAN ID substitution on the port that connects to the service provider network.
Follow these steps to configure inner VLAN ID substitution:
To do...
Enter system view
Create a class and enter class view
Configure a match criterion to match the
specified inner VLAN IDs
Configure a match criterion to match the
specified outer VLAN IDs
Return to system view
Create a traffic behavior and enter traffic
behavior view
Configure the action of marking the inner
VLAN IDs
Return to system view
Create a QoS policy and enter QoS
policy view
Associate the traffic class with the traffic
behavior defined earlier
Return to system view
Enter Layer 2 Ethernet interface view or
port group view of the service provider
network-side port
ACL and QoS Configuration Guide
Use the command...
system-view
traffic classifier classifier-name [ operator
and ]
if-match customer-vlan-id vlan-id-list
if-match service-vlan-id vlan-id
quit
traffic behavior behavior-name
remark customer-vlan-id vlan-id
quit
qos policy policy-name
classifier classifier-name behavior
behavior-name
quit
Enter Layer 2 Ethernet interface view:
interface interface-type interface-number
Enter port group view:
port-group manual port-group-name
182
.
Remarks
—
Required
By default, the
operator of a class is
AND.
Required
Required
—
Required
Required
—
Required
Required
—
Required
Use either command.