Configuring A Dynamic Aggregation Group - HP 3100 Series Configuration Manual

Configuring a dynamic aggregation group

To guarantee a successful dynamic aggregation, be sure that the peer ports of the ports aggregated
at one end are also aggregated. The two ends can automatically negotiate the aggregation state of
each member port.
Configuring a Layer 2 dynamic aggregation group
Step
Enter system
1.
view.
Set the system
2.
LACP priority.
Create a Layer 2
3.
aggregate
interface and
enter Layer 2
aggregate
interface view.
Configure the
4.
aggregation group
to operate in
dynamic
aggregation
mode.
Exit to system
5.
view.
Assign an
6.
Ethernet interface
to the aggregation
group.
Assign the port an
7.
aggregation
priority.
Set the LACP
8.
timeout interval on
the port to the
short timeout
interval (1
second).
Command
system-view
lacp system-priority system-priority
interface bridge-aggregation
interface-number
link-aggregation mode dynamic
quit
a. Enter Layer 2 Ethernet interface
view:
interface interface-type
interface-number
b. Assign the Ethernet interface to
the aggregation group:
port link-aggregation group
number
link-aggregation port-priority
port-priority
lacp period short
37
Remarks
N/A
Optional.
By default, the system LACP priority
is 32768.
Changing the system LACP priority
might affect the aggregation state of
the ports in a dynamic aggregation
group.
When you create a Layer 2
aggregate interface, the system
automatically creates a Layer 2
static aggregation group numbered
the same.
By default, an aggregation group
operates in static aggregation
mode.
N/A
Repeat this step to assign more
Layer 2 Ethernet interfaces to the
aggregation group.
Optional.
By default, the aggregation priority
of a port is 32768.
Changing the aggregation priority of
a port might affect the aggregation
state of the ports in the dynamic
aggregation group.
Optional.
By default, the LACP timeout
interval on a port is the long timeout
interval (30 seconds).