Ip Subnet-Based Vlan Configuration Example - HP 3600 v2 series Configuration Manual

To do...
Enter interface view
or port group view
Configure port link
type as hybrid
Configure the hybrid
ports to permit the
specified IP
subnet-based VLANs
to pass through
Associate the hybrid
ports with the
specified IP
subnet-based VLAN

IP subnet-based VLAN configuration example

Network requirements
As shown in
192.168.50.0/24.
Configure Device C to transmit packets over separate VLANs based on their source IP addresses.
Figure 44 Network diagram
Use the command...
Enter Layer 2 Ethernet interface view:
interface interface-type interface-number
Enter Layer 2 aggregate interface view:
interface bridge-aggregation
interface-number
Enter port group view:
port-group manual port-group-name
port link-type hybrid
port hybrid vlan vlan-id-list { tagged |
untagged }
port hybrid ip-subnet-vlan vlan vlan-id
Figure 44, the hosts in the office belong to different IP subnets 192.168.5.0/24 and
Remarks
Required
Use any command.
•
•
•
Required
By default, all ports are access ports.
Required
By default, a hybrid port allows only
packets from VLAN 1 to pass through
untagged.
Required
Not configured by default.
137
The configuration made in Ethernet
interface view applies only to the port.
The configuration made in port group
view applies to all ports in the port
group.
The configuration made in Layer 2
aggregate interface view applies to
the aggregate interface and its
aggregation member ports. If the
system fails to apply the configuration
to the aggregate interface, it stops
applying the configuration to
aggregation member ports. If the
system fails to apply the configuration
to an aggregation member port, it
skips the port and moves to the next
member port.