Assigning A Trunk Port To A Vlan - HP 3600 v2 series Configuration Manual

Follow these steps to assign an access port (in interface view) or multiple access ports (in port group view)
to a VLAN:
To do...
Enter system view
Enter interface view or port
group view
Configure the link type of
the ports as access
Assign the access ports to
a VLAN
NOTE:
Before you assign an access port to a VLAN, create the VLAN.
•
• In VLAN view, you can assign only Layer 2 Ethernet interfaces to the VLAN.

Assigning a trunk port to a VLAN

A trunk port can carry multiple VLANs. You can assign it to a VLAN in interface view (including Layer 2
Ethernet interface view, and Layer 2 aggregate interface view) or port group view.
Use the command...
system-view
Enter Layer 2 Ethernet
interface view:
interface interface-type
interface-number
Enter Layer 2 aggregate
interface view:
interface
bridge-aggregation
interface-number
Enter port group view:
port-group manual
port-group-name
port link-type access
port access vlan vlan-id
121
Remarks
—
Required
Use any command.
•
The configuration made in Layer 2 Ethernet
interface view applies only to the port.
•
The configuration made in port group view
applies to all ports in the port group.
•
The configuration made in Layer 2 aggregate
interface view applies to the aggregate interface
and its aggregation member ports. If the system
fails to apply the configuration to the aggregate
interface, it stops applying the configuration to
aggregation member ports. If the system fails to
apply the configuration to an aggregation
member port, it skips the port and moves to the
next member port.
Optional
By default, all ports are access ports.
Optional
By default, all access ports belong to VLAN 1.