Configuring Many-To-One Vlan Mapping - HP 3600 v2 series Configuration Manual

To do...
Enter Ethernet interface view
Configure the port as a trunk port
Assign the port to CVLANs and
SVLANs
Enable basic QinQ
Apply the uplink policy to the
incoming traffic
Apply the downlink policy to the
outgoing traffic
Configuring the network-side port
Follow these steps to configure the network-side port:
To do...
Enter system view
Enter Ethernet interface view
Configure the port as a trunk
port
Assign the port to SVLANs

Configuring many-to-one VLAN mapping

Perform many-to-one VLAN mapping on campus switches (see
traffic from different users in one VLAN.
Perform these tasks to configure many-to-one VLAN mapping:
Task
Enabling DHCP snooping
Enabling ARP detection in SVLANs
Configuring an uplink policy
Configuring the customer-side port
Configuring the network-side port
Use the command...
interface interface-type
interface-number
port link-type trunk
port trunk permit vlan
{ vlan-id-list | all }
qinq enable
qos apply policy
policy-name inbound
qos apply policy
policy-name outbound
Use the command...
system-view
interface interface-type
interface-number
port link-type trunk
port trunk permit vlan
{ vlan-id-list | all }
Description
Enables DHCP snooping globally (required).
Enables ARP detection in all SVLANs (required).
Configures an uplink policy for the customer-side port (required).
Configures VLAN and other settings required for many-to-one
VLAN mapping (required).
Configures VLAN and other settings required for many-to-one
VLAN mapping (required).
200
Remarks
—
Required
The default link type of an Ethernet port is
access.
Required
By default, a trunk port is in only VLAN 1.
Required
By default, basic QinQ is disabled.
Required
Required
Remarks
—
—
Required
The default link type of ports is access.
Required
By default, a trunk port is in only VLAN 1.
Figure 63) to transmit the same type of