Security Mode And Normal Mode Of Voice Vlans - HP 3600 v2 series Configuration Manual

Table 16 Required configurations on ports of different link types for them to support tagged voice traffic
Port link
type
Access
Trunk
Hybrid
IP phones send untagged voice traffic
•
When IP phones send untagged voice traffic, you can only configure the voice traffic receiving ports on
the device to operate in manual voice VLAN assignment mode.
Table 17 Required configurations on ports of different link types for them to support tagged voice traffic
Port link
type
Access
Trunk
Hybrid
NOTE:
The PVID is VLAN 1 for all ports by default. You can configure the PVID of a port and assign a port to
•
certain VLANs by using commands. For more information, see the chapter "VLAN configuration."
Use the display interface command to display the PVID of a port and the VLANs to which the port is
•
assigned.

Security mode and normal mode of voice VLANs

Depending on their inbound packet filtering mechanisms, voice VLAN-enabled ports operate in the
following modes:
Normal mode: Voice VLAN-enabled ports receive packets that carry the voice VLAN tag, and
•
forward packets in the voice VLAN without comparing their source MAC addresses against the OUI
addresses configured for the device. If the PVID of the port is the voice VLAN and the port works in
Voice VLAN Support for tagged
assignment mode voice traffic
Automatic
No
Manual
Automatic
Yes
Manual
Automatic
Yes
Manual
Voice VLAN Support for untagged
assignment mode voice traffic
Automatic No
Manual Yes
Automatic No
Manual Yes
Automatic No
Manual Yes
Configuration requirements
—
The PVID of the port cannot be the voice VLAN.
The PVID of the port cannot be the voice VLAN.
Configure the port to permit packets of the voice
VLAN to pass through.
The PVID of the port cannot be the voice VLAN.
The PVID of the port cannot be the voice VLAN.
Configure the port to permit packets of the voice
VLAN to pass through tagged.
Configuration requirements
—
Configure the PVID of the port as the voice VLAN.
—
Configure the PVID of the port as the voice VLAN
and assign the port to the voice VLAN.
—
Configure the PVID of the port as the voice VLAN
and configure the port to permit packets of the
voice VLAN to pass through untagged.
154