Configuring A Dynamic Aggregation Group - HP 6125XLG Configuration Manual

Step
4. Assign an interface to the
specified Layer 3 aggregation
group.

Configuring a dynamic aggregation group

To guarantee a successful dynamic aggregation, make sure that the peer ports of the ports aggregated
at one end are also aggregated. The two ends can automatically negotiate the aggregation state of each
member port.
Configuring a Layer 2 dynamic aggregation group
Step
1. Enter system view.
2. Set the system LACP priority.
Create a Layer 2 aggregate
3.
interface and enter Layer 2
aggregate interface view.
4. Configure the aggregation
group to operate in dynamic
aggregation mode.
5. Exit to system view.
6. Assign an interface to the
specified Layer 2 aggregation
group.
Set LACP to operate in active
7.
mode.
8. Configure the port priority for
the interface.
Command
a. Enter Layer 3 Ethernet
interface view:
interface interface-type
interface-number
b. Assign the interface to the
specified Layer 3
aggregation group:
port link-aggregation
group number
Command
system-view
lacp system-priority system-priority
interface bridge-aggregation
interface-number
link-aggregation mode dynamic
quit
a. Enter Layer 2 Ethernet
interface view:
interface interface-type
interface-number
b. Assign the interface to the
specified Layer 2
aggregation group:
port link-aggregation
group number
undo lacp mode
link-aggregation port-priority
port-priority
47
Remarks
Repeat these two sub-steps to
assign more Layer 3 Ethernet
interfaces to the aggregation
group.
Remarks
N/A
By default, the system LACP priority
is 32768.
Changing the system LACP priority
might affect the aggregation state
of the ports in a dynamic
aggregation group.
When you create a Layer 2
aggregate interface, the system
automatically creates a Layer 2
static aggregation group
numbered the same.
By default, an aggregation group
operates in static aggregation
mode.
N/A
Repeat these two sub-steps to
assign more Layer 2 Ethernet
interfaces to the aggregation
group.
By default, LACP is operating in
active mode.
The default setting is 32768.