HP 3600 v2 series Configuration Manual page 193

Configure Ethernet 1/0/3.
•
# Configure Ethernet 1/0/3 as a trunk port and assign it to VLAN 200.
[PE1] interface ethernet 1/0/3
[PE1-Ethernet1/0/3] port link-type trunk
[PE1-Ethernet1/0/3] port trunk permit vlan 200
# Configure VLAN 200 as the PVID for the port.
[PE1-Ethernet1/0/3] port trunk pvid vlan 200
# Enable basic QinQ on the port.
[PE1-Ethernet1/0/3] qinq enable
[PE1-Ethernet1/0/3] quit
Configure PE 2.
2.
Configure Ethernet 1/0/1.
•
# Configure Ethernet 1/0/1 as a trunk port and assign it to VLAN 200.
<PE2> system-view
[PE2] interface ethernet 1/0/1
[PE2-Ethernet1/0/1] port link-type trunk
[PE2-Ethernet1/0/1] port trunk permit vlan 200
# Configure VLAN 200 as the PVID for the port.
[PE2-Ethernet1/0/1] port trunk pvid vlan 200
# Enable basic QinQ on the port.
[PE2-Ethernet1/0/1] qinq enable
[PE2-Ethernet1/0/1] quit
Configure Ethernet 1/0/2.
•
# Configure Ethernet 1/0/2 as a trunk port and assign it to VLAN 100 and VLAN 200.
[PE2] interface ethernet 1/0/2
[PE2-Ethernet1/0/2] port link-type trunk
[PE2-Ethernet1/0/2] port trunk permit vlan 100 200
# Set the TPID value in the outer VLAN tag to 0x8200 on the port.
[PE2-Ethernet1/0/2] qinq ethernet-type service-tag 8200
[PE2-Ethernet1/0/2] quit
Configure Ethernet 1/0/3.
•
# Configure Ethernet 1/0/3 as a trunk port and assign it to VLAN 100.
[PE2] interface ethernet 1/0/3
[PE2-Ethernet1/0/3] port link-type trunk
[PE2-Ethernet1/0/3] port trunk permit vlan 100
# Configure VLAN 100 as the PVID for the port.
[PE2-Ethernet1/0/3] port trunk pvid vlan 100
# Enable basic QinQ on the port.
[PE2-Ethernet1/0/3] qinq enable
[PE2-Ethernet1/0/3] quit
Configure third-party devices.
3.
On the third-party devices between PE 1 and PE 2, configure the port that connects to PE 1 and that
connecting to PE 2 to allow tagged frames of VLAN 100 and VLAN 200 to pass through.
185