Protocol-Based Vlan Configuration Example - HP 3600 v2 series Configuration Manual

To do...
Enter interface view or
port group view
Configure the port link
type as hybrid
Assign the hybrid port to
the specified
protocol-based VLANs
Assign the protocol
template you have
created to the hybrid
port
CAUTION:
A protocol-based VLAN processes only untagged inbound packets, whereas the voice VLAN in automatic
mode processes only tagged voice traffic. Do not configure a VLAN as both a protocol-based VLAN and
a voice VLAN. For more information, see the chapter "Voice VLAN configuration."

Protocol-based VLAN configuration example

Network requirements
In a lab environment, as shown in
run the IPv6 protocol for teaching purposes. To avoid interference, isolate IPv4 traffic and IPv6 traffic at
Layer 2.
Use the command...
Enter Layer 2 Ethernet interface
view:
interface interface-type
interface-number
Enter Layer 2 aggregate interface
view:
interface bridge-aggregation
interface-number
Enter port group view:
port-group manual
port-group-name
port link-type hybrid
port hybrid vlan vlan-id-list { tagged
| untagged }
port hybrid protocol-vlan vlan
vlan-id { protocol-index [ to
protocol-end ] | all }
Figure 43, most hosts run the IPv4 protocol, and the rest of the hosts
133
Remarks
Required
Use any command.
•
The configuration made in Ethernet
interface view applies only to the port.
•
The configuration made in port group
view applies to all ports in the port group.
•
The configuration made in Layer 2
aggregate interface view applies to the
aggregate interface and its aggregation
member ports. If the system fails to apply
the configuration to the aggregate
interface, it stops applying the
configuration to aggregation member
ports. If the system fails to apply the
configuration to an aggregation member
port, it skips the port and moves to the
next member port.
Required
By default, all ports are access ports.
Required
By default, a hybrid port is only in VLAN 1.
Required