Enabling Link State Traps For An Aggregate Interface; Setting The Minimum Number Of Selected Ports For An Aggregation Group - HP 3600 v2 series Configuration Manual

Enabling link state traps for an aggregate interface

You can configure an aggregate interface to generate linkUp trap messages when its link goes up and
linkDown trap messages when its link goes down. For more information, see Network Management and
Monitoring Configuration Guide.
Follow these steps to enable link state traps on an aggregate interface:
To do...
Enter system view
Enable the trap function globally
Enter
aggregat
e interface
view
Enable link state traps for the
aggregate interface
Setting the minimum number of Selected ports for an
aggregation group
The bandwidth of an aggregate link increases along with the number of selected member ports. To avoid
congestion caused by insufficient Selected ports on an aggregate link, you can set the minimum number
of Selected ports required for bringing up the specific aggregate interface.
This minimum threshold setting affects the aggregation state of both aggregation member ports and the
aggregate interface in the following ways:
• All member ports change to the Unselected state and the link of the aggregate interface goes down,
when the number of member ports eligible for being selected is smaller than the minimum
threshold.
When the minimum threshold is reached, the eligible member ports change to the Selected state,
•
and the link of the aggregate interface goes up.
Follow these steps to set the minimum number of Selected ports for an aggregation group:
To do...
Enter system view
Enter
aggregate
interface
view
Set the minimum number of Selected ports
for the aggregation group
Enter Layer 2
aggregate interface
view
Enter Layer 3
aggregate interface
Enter Layer 2 aggregate
interface view
Enter Layer 3 aggregate
interface view
Use the command...
system-view
snmp-agent trap enable [ standard
[ linkdown | linkup ] * ]
interface bridge-aggregation
interface-number
interface route-aggregation
interface-number
enable snmp trap updown
Use the command...
system-view
interface bridge-aggregation
interface-number
interface route-aggregation
interface-number
link-aggregation selected-port
minimum number
43
Remarks
—
Optional
By default, link state trapping is
enabled globally and on all
interfaces.
Required
Use either command.
Optional
Enabled by default.
Remarks
—
Required
Use either command.
Required
Not specified by default.