HP 3600 v2 series Configuration Manual page 210

To do...
Create a traffic behavior and enter
traffic behavior view
Configure an SVLAN marking
action
Return to system view
Create a QoS policy and enter
QoS policy view
Map the CVLANs to the SVLAN by
associating the class with the
behavior
Configuring the customer-side port
Follow these steps to configure the customer-side port:
To do...
Enter system view
Enter Ethernet interface view
Configure the port as a trunk port
Assign the port to CVLANs and
SVLANs
Set the port as a DHCP snooping
trusted port
Enable customer-side QinQ
Apply the uplink policy to the
incoming traffic
CAUTION:
Before applying a QoS policy to the customer-side port, enable customer-side QinQ on the port. Before
disabling customer-side QinQ on the customer-side port, remove the QoS policy from the port first.
Configuring the network-side port
Follow these steps to configure the network-side port:
To do...
Enter system view
Enter Ethernet interface view
Use the command...
traffic behavior behavior-name
remark service-vlan-id vlan-id
quit
qos policy policy-name
classifier tcl-name behavior
behavior-name mode
dot1q-tag-manipulation
Use the command...
system-view
interface interface-type
interface-number
port link-type trunk
port trunk permit vlan
{ vlan-id-list | all }
dhcp-snooping trust
qinq enable downlink
qos apply policy
policy-name inbound
Use the command...
system-view
interface interface-type
interface-number
202
Remarks
Required
Repeat these steps to configure one
behavior for each SVLAN.
Required
Required
Repeat this step to create other
CVLANs-to-SVLAN mappings.
Remarks
—
—
Required
The default link type of an Ethernet port is
access.
Required
By default, a trunk port is in only VLAN 1.
Required
By default, all ports are DHCP snooping
untrusted ports.
Required
By default, customer-side QinQ is disabled
on all ports.
Required
Remarks
—
—