Gvrp Forbidden Registration Mode Configuration Example - HP 3600 v2 series Configuration Manual

[DeviceB-Ethernet1/0/1] port link-type trunk
[DeviceB-Ethernet1/0/1] port trunk permit vlan all
# Enable GVRP on Ethernet 1/0/1, and set the GVRP registration mode to fixed on the port.
[DeviceB-Ethernet1/0/1] gvrp
[DeviceB-Ethernet1/0/1] gvrp registration fixed
[DeviceB-Ethernet1/0/1] quit
# Create VLAN 3 (a static VLAN).
[DeviceB] vlan 3
[DeviceB-vlan3] quit
Verify the configuration.
3.
Use the display gvrp local-vlan command to display the local VLAN information that GVRP maintains on
ports. For example:
# Display the local VLAN information that GVRP maintains on port Ethernet 1/0/1 of Device A.
[DeviceA] display gvrp local-vlan interface ethernet 1/0/1
Following VLANs exist in GVRP local database:
1(default), 2
According to the output, information about VLAN 1 and static VLAN information of VLAN 2 on the local
device are registered through GVRP, but dynamic VLAN information of VLAN 3 on Device B is not.
# Display the local VLAN information that GVRP maintains on port Ethernet 1/0/1 of Device B.
[DeviceB] display gvrp local-vlan interface ethernet 1/0/1
Following VLANs exist in GVRP local database:
1(default), 3
According to the output, information about VLAN 1 and static VLAN information of VLAN 3 on the local
device are registered through GVRP, but dynamic VLAN information of VLAN 2 on Device A is not.

GVRP forbidden registration mode configuration example

Network requirements
As shown in
• Device A and Device B are connected through their ports Ethernet 1/0/1.
Enable GVRP and configure the forbidden registration mode on ports to prevent the registration and
•
deregistration of all VLANs but VLAN 1 between the two devices.
Figure 56 Network diagram
Configuration procedure
Configure Device A.
1.
# Enable GVRP globally.
<DeviceA> system-view
[DeviceA] gvrp
# Configure port Ethernet 1/0/1 as a trunk port, and assign it to all VLANs.
Figure 56:
172