Configuring The Tpid Value In Vlan Tags; Qinq Configuration Examples; Basic Qinq Configuration Example - HP 3600 v2 series Configuration Manual

To do...
Apply the QoS policy to the outgoing
traffic

Configuring the TPID value in VLAN tags

Follow these steps to configure the TPID value of a VLAN tag:
To do...
Enter system view
Configure the TPID in the
customer network VLAN tags
Enter interface view or port
group view of the service
provider network-side port
Configure the TPID in the
service provider network
VLAN tags
NOTE:
You cannot configure the SVLAN TPID and QinQ on a port at the same time.

QinQ configuration examples

Basic QinQ configuration example

Network requirements
As shown in
• The two branches of Company A, Site 1 and Site 2, are connected through the service provider
network and use CVLANs 10 through 70. The two branches of Company B, Site 3 and Site 4, are
connected through the service provider network and use CVLANs 30 through 90.
PE 1 and PE 2 are edge devices on the service provider network and are connected through
•
third-party devices with a TPID value of 0x8200.
Configure the edge and third-party devices to enable communication between the branches of
•
Company A through SVLAN 100, and communication between the branches of Company B
through SVLAN 200.
Use the command...
system-view
qinq ethernet-type customer-tag hex-value
Enter Layer 2 Ethernet interface view or Layer 2
aggregate interface view:
interface interface-type interface-number
Enter port group view:
port-group manual port-group-name
qinq ethernet-type service-tag hex-value
Figure 60:
Use the command...
qos apply policy policy-name outbound
183
Remarks
Required
Remarks
—
Optional
0x8100 by default.
Required
Use either command.
Optional
0x8100 by default.