Ethernet Link Aggregation Configuration Examples; Layer 2 Static Aggregation Configuration Example - HP 3600 v2 series Configuration Manual

To do...
Display summary information
about all aggregation groups
Display detailed information about
a specific or all aggregation
groups
Clear LACP statistics for a specific
or all link aggregation member
ports
Clear statistics for a specific or all
aggregate interfaces

Ethernet link aggregation configuration examples

NOTE:
In an aggregation group, only ports that have the same port attributes and class-two configurations (see
"Configuration
sure that all member ports have the same port attributes and class-two configurations as the reference
port. The other settings only need to be configured on the aggregate interface, not on the member ports.

Layer 2 static aggregation configuration example

Network requirements
As shown in
Device A and Device B are connected through their respective Layer 2 Ethernet interfaces Ethernet
•
1/0/1 through Ethernet 1/0/3.
Configure a Layer 2 static aggregation group on Device A and Device B, respectively. Enable VLAN
•
10 at one end of the aggregate link to communicate with VLAN 10 at the other end, and VLAN 20
at one end to communicate with VLAN 20 at the other end.
Enable traffic to be load-shared across aggregation group member ports based on the source and
•
destination MAC addresses.
classes") as the reference port (see
Figure 12:
Use the command...
display link-aggregation summary [ | { begin |
exclude | include } regular-expression ]
display link-aggregation verbose
[ { bridge-aggregation | route-aggregation }
[ interface-number ] ] [ | { begin | exclude |
include } regular-expression ]
reset lacp statistics [ interface interface-list ]
reset counters interface [ { bridge-aggregation |
route-aggregation } [ interface-number ] ]
"Reference
48
Remarks
Available in any view
Available in any view
Available in user
view
Available in user
view
port") can operate as Selected ports. Make