HP 3600 v2 series Configuration Manual page 63

[DeviceA] link-aggregation load-sharing mode source-ip destination-ip
Configure Device B.
2.
Configure Device B using the same instructions that you used to configure Device A.
Verify the configurations.
3.
# Display summary information about all aggregation groups on Device A.
[DeviceA] display link-aggregation summary
Aggregation Interface Type:
BAGG -- Bridge-Aggregation, RAGG -- Route-Aggregation
Aggregation Mode: S -- Static, D -- Dynamic
Loadsharing Type: Shar -- Loadsharing, NonS -- Non-Loadsharing
Actor System ID: 0x8000, 000f-e2ff-0001
AGG AGG
Interface Mode
-------------------------------------------------------------------------------
RAGG1 D
The output shows that link aggregation group 1 is a load-shared Layer 3 dynamic aggregation group
and it contains three Selected ports.
# Display the global link-aggregation load-sharing criteria on Device A.
[DeviceA] display link-aggregation load-sharing mode
Link-Aggregation Load-Sharing Mode:
destination-ip address,
The output shows that the global link-aggregation load-sharing criteria are the source and destination IP
addresses of packets.
Partner ID
0x8000, 000f-e2ff-0002
source-ip address
55
Select Unselect Share
Ports Ports Type
3 0 Shar