Mac Information Configuration Example - HP 3600 v2 series Configuration Manual

MAC Information configuration example

Network requirements
As shown in
• Host A is connected to a remote server (Server) through Device.
Enable MAC Information on Ethernet 1/0/1 on Device. Device sends MAC address changes in
•
Syslog messages to Host B through Ethernet 1/0/3. Host B analyzes and displays the Syslog
messages.
Figure 7 Network diagram
Configuration procedure
Configure Device to send Syslog messages to Host B.
1.
For more information, see Network Management and Monitoring Configuration Guide.
Enable MAC Information.
2.
# Enable MAC Information on Device.
<Device> system-view
[Device] mac-address information enable
# Configure MAC Information mode as Syslog.
[Device] mac-address information mode syslog
# Enable MAC Information on Ethernet 1/0/1.
[Device] interface ethernet 1/0/1
[Device-Ethernet1/0/1] mac-address information enable added
[Device-Ethernet1/0/1] mac-address information enable deleted
[Device-Ethernet1/0/1] quit
# Set the MAC Information queue length to 100.
[Device] mac-address information queue-length 100
# Set the interval for sending Syslog or trap messages to 20 seconds.
[Device] mac-address information interval 20
Figure 7:
30