Assigning A Hybrid Port To A Vlan - HP 3600 v2 series Configuration Manual

Follow these steps to assign a trunk port to one or multiple VLANs:
To do...
Enter system view
Enter interface
view or port group
view
Configure the link
type of the ports as
trunk
Assign the trunk
ports to the
specified VLANs
Configure the
PVID of the trunk
ports
NOTE:
To change the link type of a port from trunk to hybrid or vice versa, you must set the link type to access
•
first.
After configuring the PVID for a trunk port, you must use the port trunk permit vlan command to
•
configure the trunk port to allow packets from the PVID to pass through, so that the egress port can
forward packets from the PVID.

Assigning a hybrid port to a VLAN

A hybrid port can carry multiple VLANs. You can assign it to a VLAN in interface view (including Ethernet
interface view, and Layer 2 aggregate interface view) or port group view.
Follow these steps to assign a hybrid port to one or multiple VLANs:
To do...
Enter system view
Use the command...
system-view
Enter Layer 2 Ethernet interface view:
interface interface-type
interface-number
Enter Layer 2 aggregate interface
view:
interface bridge-aggregation
interface-number
Enter port group view:
port-group manual port-group-name
port link-type trunk
port trunk permit vlan { vlan-id-list |
all }
port trunk pvid vlan vlan-id
Use the command...
system-view
Remarks
—
Required
Use any command.
•
The configuration made in Layer 2 Ethernet
interface view applies only to the port.
•
The configuration made in port group view
applies to all ports in the port group.
•
The configuration made in Layer 2
aggregate interface view applies to the
aggregate interface and its aggregation
member ports. If the system fails to apply the
configuration to the aggregate interface, it
stops applying the configuration to
aggregation member ports. If the system
fails to apply the configuration to an
aggregation member port, it skips the port
and moves to the next member port.
Required
By default, all ports are access ports.
Required
By default, a trunk port carries only VLAN 1.
Optional
By default, the PVID is VLAN 1.
Remarks
—
122