Configuring A Layer 2 Dynamic Aggregation Group - HP A5830 Configuration Manual

Step...
6. Assign the port an
aggregation priority

Configuring a Layer 2 dynamic aggregation group

To guarantee a successful dynamic aggregation, be sure that the peer ports of the ports aggregated at
one end are also aggregated. The two ends can automatically negotiate the aggregation state of each
member port.
To configure a Layer 2 dynamic aggregation group:
Step...
1. Enter system view
2. Set the system LACP
priority
3. Create a Layer 2
aggregate interface
and enter Layer 2
aggregate interface
view
4. Configure the
aggregation group
to work in dynamic
aggregation mode
5. Exit to system view
6. Enter Layer 2
Ethernet interface
view
7. Assign the Ethernet
interface to the
aggregation group
8. Assign the port an
aggregation priority
Command...
link-aggregation port-
priority port-priority
Command...
system-view
lacp system-priority
system-priority
interface bridge-
aggregation interface-
number
link-aggregation mode
dynamic
quit
interface interface-type
interface-number
port link-aggregation
group number
link-aggregation port-
priority port-priority
34
Remarks
Optional
By default, the aggregation priority of a port is
32,768
Changing the aggregation priority of a port can
affect the aggregation state of the ports in the
static aggregation group
Remarks
—
Optional
By default, the system LACP priority is 32,768
Changing the system LACP priority can affect the
aggregation state of the ports in a dynamic
aggregation group
Required
When you create a Layer 2 aggregate interface, the
system automatically creates a Layer 2 static
aggregation group numbered the same
Required
By default, an aggregation group works in static
aggregation mode
—
Required
Repeat these two steps to assign more Layer 2
Ethernet interfaces to the aggregation group
Optional
By default, the aggregation priority of a port is
32,768
Changing the aggregation priority of a port can affect
the aggregation state of the ports in the dynamic
aggregation group