RUN Mode
Proper programming and successful zero and span calibration allow entry into the RUN
mode. Otherwise, entry is denied and the first missing item of programming or calibration
is displayed.
Press
Rate
Total 1
Once the initial programming is complete and the BW500 and BW500/L is operating in the
RUN mode, you may now put the belt conveyor into normal service. The BW500 is
functioning under its initial program and calibration, reporting rate of material flow and
totalizing.
Page 40
Milltronics BW500 and BW500/L - OPERATING INSTRUCTIONS 7ML19985DK05
e.g. if there is no material on the belt and
0.00 t/h
the conveyor is running. The current rate is
0.00 t
0 and no material has been totalized.