Siemens Milltronics BW500 Operating Lnstructions page 36

Press
P011 Design Rate:
Enter Rate
Or press
P940-2 Load Cell mV Signal Test
mV reading for B
To change a parameter value
P011 Design Rate:
Enter Rate
Press
P011 Design Rate:
Enter Rate
Press
P014 Design Speed
Enter Speed
To reset a parameter value
Press
P011 Design Rate:
Enter Rate
Press
P011 Design Rate:
Enter Rate
Page 30 Milltronics BW500 and BW500/L - OPERATING INSTRUCTIONS 7ML19985DK05
in sequence.
V
100.00 kg/h
For direct access to index parameters
V
6.78
V
100.00 kg/h
E
100.00 kg/h
Enter the new value
V
0.08 m/S
E
100.00 kg/h
V
0.00 kg/h
e.g. access P011, design rate
e.g. access P940-2, load cell B mV signal
from the view mode
If edit mode is not enabled after pressing
ENTER, security is locked. Refer to
rity Lock (P000)
on page 111 for instruc-
tions on disabling
For P001 to P017, ENTER effects the
change and scrolls to the next required
parameter.
From the edit mode
Value is reset to factory value.
e.g. 0.00 kg/h
Secu-