Siemens Milltronics BW500 Operating Lnstructions page 19

Installation
1. Isolate power and voltages applied to the BW500
2. Open the lid
3. Install the board by mating the connectors and secure the card in place using
the three screws provided
4. Close the lid
5. Apply power and voltage to the BW500
Refer to:
Specifications
•
mA I/O board
•
mA I/O Parameters (P200 - P220)
•
mA I/O (0/4-20 mA)
•
mA I/O board
7ML19985DK05Milltronics BW500 and BW500/L - OPERATING INSTRUCTIONS
on page 8
connections on page 27
on page 119
Operation
in the
SmartLinx®
section on page 66
route SmartLinx®
cable along right
hand wall
Page 13