Siemens Milltronics BW500 Operating Lnstructions page 133

P359 Factoring
Factoring is used as a method of calculating the value of the test load (P017) to a new test
reference; either: weight, or chain. The task is performed only for the weight or chain
relevant for the multispan selected, if applicable.
Entry:
f
1 = weight ( = 1)
2 = chain
Recalibration
Refer to
Note:
only upon return to the RUN mode.
P360 Calibration Duration
Sets the number of whole belt revolutions to be used during a zero or span calibration.
Enter number of belt revolutions, range 1 to 99. For belt scale applications 1 belt
revolution or 2 minutes, whichever is longer; for weghfeeder applications 3 belt
revolutions or 5 minutes, whichever is longer.
P365 Multispan
Select the span reference to be applied for determination of rate and totalization.
Entry:
1 = multispan 1 (MS1), for product or condition A
2 = multispan 2 (MS2), for product or condition B
3 = multispan 3 (MS3), for product or condition C
4 = multispan 4 (MS4), for product or condition D
5 = multispan 5 (MS5), for product or condition E
6 = multispan 6 (MS6), for product or condition F
7 = multispan 7 (MS7), for product or condition G
8 = multispan 8 (MS8), for product or condition H
Multispan
Refer to
P367 Direct Zero Entry
Directly enters the zero reference count.
Direct entry is intended for use when replacing software or hardware and it is not
convenient to perform an initial zero at that time (
Recalibration
Refer to
1)
Not available with BW500/L.
7ML19985DK05Milltronics BW500 and BW500/L - OPERATING INSTRUCTIONS
on page 41 for execution of the factoring procedure.
Totalization is halted during the factoring procedure, and resumed
1)
on page 50 and P270, Auxiliary Input Function (6) on page 122.
on page 41 for execution.
f
f
= 0).
Page 127