Auxiliary Speed Sensor - Siemens Milltronics BW500 Operating Lnstructions

Auxiliary Speed Sensor

Shields are common, but not grounded to chassis. Run cable shields through
Note:
SHLD terminals and ground at BW500 only.
Connect BW500 terminal 24-28 to speed sensor terminal:
• '2' for clockwise speed sensor shaft rotation
• '3' for counter-clockwise speed sensor shaft rotation.
Speed sensor shaft rotation is viewed from the front cover of the speed sensor
enclosure.
Input device in the form of open collector transistor or dry contact across BW500
terminals 24-28 will also serve as a suitable speed signal.
If a speed sensor other than the models shown is supplied, consult with Siemens.
1)
Not available for BW500/L.
7ML19985DK05Milltronics BW500 and BW500/L - OPERATING INSTRUCTIONS
1)
Page 21