Appendix Ii: Software Revision History - Siemens Milltronics BW500 Operating Lnstructions

Appendix II: Software Revision History

Software
Revision
2.00 April 30, 1999
2.01 July 20, 1999
2.02 October 08, 1999
2.03 May 16, 2000
2.04 June 30, 2000
2.05 February 07, 2001
2.06 February 17, 2001
Page 156 Milltronics BW500 and BW500/L - OPERATING INSTRUCTIONS 7ML19985DK05
Date
• Original software release
• French language added
• 38400 baud rate option removed
• Span updated to reference current zero
value
• NTEP printout added
• Totalizer rollover updated to 1,000,000
for all resolutions
• Added units to verification totalizer
printout
• Error display updated to toggle
between error and run mode
• Limited external contact closure to 300
msec
• Added software filter to speed signal
• Factoring now based on current zero
value
• Individual damping added for Rate,
Load and Speed display
• Parameters saved permanently in Flash
• German added
• Devicenet added
• Display only the load cells selected
• Allow proper startup if no RAM battery
installed
• Larger flash added
• SmartLinx update time increased to 250
msec.
• Batch totalizer was made accessible
using Modbus
• New real time clock added
• BW500 calibrations no longer affected
by time out
• Auto Zero alarm relay will now reset
toggling from program to run mode
• Updated calibration error so that it will
not display a negative 0 error, -0.00%
Changes