Optional Plug-Ins; Smartlinx7 Module; Ma I/O Board - Siemens Milltronics BW500 Operating Lnstructions

Optional Plug-ins

SmartLinx 7 Module
BW500 and BW500/L is software/hardware ready to accept the optional Siemens
SmartLinx® communications module that provides an interface to one of several popular
industrial communications systems.
BW500 and BW500/L may be shipped to you without a SmartLinx®module, for
installation at a later date.
If you are ready to install your SmartLinx® module, or want to change it, please follow
the instructions as outlined.
Installation
1. Isolate power and voltages applied to the BW500 and BW500/L
2. Open the lid
3. Install the module by mating the connectors and secure in place using the two
screws provided
4. Route communication cable to SmartLinx®module along the right side of the
enclosure wall. This route will reduce communication
Refer to the SmartLinx® documentation for any required hardware settings
Note:
prior to closing the lid.
5. Close the lid.
6. Apply power and voltage to the BW500 and BW500/L.
Refer to:
• SmartLinx®Module in the
P750 – P769 SmartLinx
•
manual
• the SmartLinx® manual for wiring
1)

mA I/O board

BW500 is software/hardware ready to accept the optional mA I/O board. The mA I/O
board provides 2 programmable 0/4-20 mA outputs, 2 programmable 0/4-20 mA inputs and
a nominal 24 V DC supply for loop powered devices.
BW500 may be shipped to you without an mA I/O board, for installation at a later date.
If you are ready to install your mA I/O board, please follow the instructions as outlined.
1)
Not available with the BW500/L
Page 12 Milltronics BW500 and BW500/L - OPERATING INSTRUCTIONS 7ML19985DK05
Specifications
section on page 5
Module Specific Parameters
® on page 143 in this