Table D-1 Model 182 Device-Dependent Command Summary - Keithley 2182 User Manual

D-2 Model 182 Emulation Commands
The Model 2182 can be configured to accept device-dependent commands of the Keithley
Model 182 Sensitive Digital Voltmeter. The commands for controlling the Model 2182 with the
182 language are provided in
Model 182 Instruction Manual.
Since the architecture of the Model 2182 differs from that of the Model 182, some commands
are different and cannot be used. Be sure to refer to the notes at the end of the table for
information on command restrictions.
CAUTION
Table D-1
Model 182 device-dependent command summary
Mode
Display ASCII String
Display Resolution
Calibration
Filter Damping
Reading Source
Reading Format
Immediate Trigger
Buffer Configuration
Analog Output
Relative
EOI, Bus Hold-off
Table
The 182 language is intended to be used only over the IEEE-488 bus. Using
front panel controls in conjunction with this language may cause erratic
operation. In this case, results cannot be guaranteed.
Command Description
A0 Restore display to normal
A1,string Display string (up to 12 characters)
B0 5 -digit resolution
B1 6 -digit resolution
B2 3 -digit resolution
B3 4 -digit resolution
None C (Calibration) commands not supported
D0 Configure filter damping off (same as P2)
D1 Configure filter damping on (same as P3)
F0 Latest reading from A/D converter
F1 One reading from buffer
F2 All readings in buffer
F3 Maximum value in buffer
F4 Minimum value in buffer
G0 Reading only
G1 Reading with prefix
G2 Reading with buffer location
G3 Reading with buffer location and prefix
H0 Initiate manual trigger
I0 Disable buffer
I1,value Buffer on, value = buffer size
J0 Disable analog output relative
J1 Enable analog output relative using last reading as Rel
value
J2,value Enable analog output relative using value (±1e–9 to ±120)
J3 Enable analog output relative
K0 Enable EOI, enable bus hold-off on X
K1 Disable EOI, enable bus hold-off on X
D-1. For details on Model 182 operation, refer to the
Note
1
2
3
4
5
6