14-4
SCPI Reference Tables
Table 14-1
CALCulate command summary (cont.)
Command
[:IMMediate]
:AUTO <b>
:AUTO?
:LIMit2
:UPPer
[:DATA] <n>
[:DATA]?
:LOWer
[:DATA] <n>
[:DATA]?
:STATe <b>
:STATe?
:FAIL?
:CLEar
[:IMMediate]
:AUTO <b>
:AUTO?
:IMMediate
Table 14-2
CALibration command summary (user accessible)
Command
:CALibration
:UNPRotected
:ACALibration
:INITiate
:STEP1
:STEP2
:DONE
:TEMPerature?
Note: The above table only provides the commands to perform ACAL, which is a procedure to be performed by the
operator. The formal calibration is to be performed by qualified service personnel and is provided in the Model 2182
Service Manual.
Description
Clear limit test results.
Enable or disable clearing of limit test results
when a new trigger model cycle starts.
Query state of auto clear.
Limit 2 Testing:
Configure upper limit:
Specify limit; -100e6 to 100e6.
Query upper limit.
Configure lower limit:
Specify limit; -100e6 to 100e6.
Query lower limit.
Enable or disable Limit 2 test.
Query state of Limit 2 test.
Return result of Limit 2 test; 0 (pass) or 1(fail).
Clear test results:
Clear limit test results.
Enable or disable clearing of limit test results
when a new trigger model cycle starts.
Query state of auto clear.
Recalculate limit tests.
Description
See Note.
Calibration accessible to operator:
ACAL procedure:
Prepares 2182 for ACAL.
Performs a full ACAL (100V and 10mV).
Performs a limited ACAL (10mV only).
Exit ACAL mode.
Queries the internal temperature at the time of last
ACAL. If present internal temperature differs from
the last ACAL temperature by more than 1°C,
perform another ACAL.
Default
Parameter
Ref
SCPI
√
ON
√
√
√
√
2
√
√
√
-2
√
√
OFF
√
√
√
√
√
ON
√
√
√
Default
Parameter
Ref
SCPI
Sec 2