Getting Started - Keithley 2182 User Manual

1-8

Getting Started

2 Function and operation keys
Top Row
Un-shifted
DCV1
DCV2
V1/V2
ACAL
FILT
REL
TEMP1
TEMP2
Shifted
MX+B
%
V1-V2
LSYNC
TYPE
OUTPUT
A
TCOUPL
Middle Row
Un-shifted
EX-TRIG
TRIG
STORE
RECALL
VALUE
ON/OFF
Shifted
DELAY
HOLD
Selects Channel 1 voltage measurement function.
Selects Channel 2 voltage measurement function.
Selects Ratio (Channel 1 voltage reading / Channel 2 voltage reading).
Selects automatic gain calibration.
Enables/disables filter for selected measurement function.
Enables/disables relative for selected measurement function.
Selects Channel 1 temperature measurement function.
Selects Channel 2 temperature measurement function.
Multiplies a scale factor (M) to the reading (X) and then adds an offset (B).
Calculates percent deviation from a specified reference.
Selects Delta; (V1t1 – V1t2)/2.
Enables/disables line cycle synchronization. When enabled, noise induced
by the power line is reduced at the expense of speed.
Select filter (analog and/or digital) and configure digital filter (window,
count and type).
Enables/disables relative for Analog Output.
Enables/disables Analog Output.
OUT
Configure temperature measurement (units, junction type, thermocouple
type, sensor type).
Selects external triggering (front panel, bus or trigger link) as trigger
source.
Triggers a measurement from the front panel.
Sets reading count for buffer and enables buffer.
Displays stored readings (including maximum, minimum, peak-to-peak,
average, and standard deviation). The
the buffer, and the
reading.
Set the upper and lower limits for limit testing.
Enables/disables limit testing, and selects beeper mode for limit testing.
and Controls cursor position for making selections or editing values.
Sets user delay between trigger and measurement.
Holds reading when the specified number of samples is within the selected
tolerance.
and
and key toggles between reading number and
range keys scroll through