Switch operation
>
∧
>
∧
>
∧
>
∧
>
∧
>
∧
>
∧
>
∧
The symbol [
7.8
Setting Display Item
7.8.1
Oxygen Analyzer - Setting Display Item
Display items are defined as items displayed on the basic panel display.
Parameter code "A00" or "F08" is used to set the display items as shown in Table 7.7. The
oxygen concentration is set at the factory before shipment. In addition, if the data initialization is
performed, the oxygen concentration will be set.
Table 7.7
Values set with A00 or F08
0
1 or 2
3
CAUTION
If you set "3" in the parameter code "A00" or "F08", be sure to select "Oxygen Concentration" in
the following mA output setting (see Section 8.1, "Current Output Setting").
Display
025
ENT
Touch the [>] key to move the position of the digit that is flashing to the
right.
085
ENT
Touch the [∧] key to change the number 2 in C25 to "8."
085
ENT
Touch the [>] key to move the position of the digit that is flashing to the
right.
080
ENT
Touch the [∧] key to change the number 5 in C85 to "0." The number
changes from 5 to 6 . to 9 to 0.
080
ENT
If you touch the [ENT] key, all the digits flash.
080
ENT
Touch the [ENT] key again to stop the flashing.
C14
ENT
Touch the [ENT] key once again to switch to the parameter code selection
display.
ENT
Basic
Touch the [>] key together with the [ENT] key to return to the basic panel
panel
display. (This is not required if you proceed to make another setting.)
display
(The displayed numeric characters indicate the measurement gas
concentration.)
] indicates that the key is being touched. Light characters indicates that the digits are flashing.
Display Item
Items displayed on the basic panel display
Indicates the oxygen concentration.
For humidity analyzers only. (if 1 or 2 is set for the oxygen analyzer,
"0.0" is only displayed on the basic panel display.)
Displays an item for the current output.
If the output damping has been set for the current output, values
involving the output damping are displayed.
<7. Startup>
Description
IM 11M12A01-04E
11th Edition : Jul. 19, 2017-00
7-12