10.3
Initialization Procedure
Follow the table below to initialize parameters. The password for initialization is 1255.
Table 10.5
Switch operation
>
∧
>
∧
>
∧
>
∧
>
∧
>
∧
>
∧
>
∧
>
∧
>
∧
>
∧
>
∧
>
∧
The symbol (
WARNING
Do not attempt to turn off the equipment power during initialization (while "USr Go" is flashing).
10.4
Reset
Resetting enables the equipment to restart. If the equipment is reset, the power is turned off
and then back on. In practical use, the power remains on, and the equipment is restarted under
program control. Resetting will be possible in the following conditions:
Initialization Procedure
Display
F30
ENT
0000
ENT
1000
ENT
1000
ENT
1200
ENT
1200
ENT
1250
ENT
1250
ENT
1255
ENT
1255
ENT
USr Go
ENT
USr Go
ENT
F30
ENT
) indicates that the keys are being touched, the light characters indicates flashing.
<10. Other Functions>
Description
Enter the parameter code for the item to be initialized.
The following show an example of entering "F30."
(Previous needed operations are omitted.)
Touch the [ENT] key to switch to the password entry display.
Enter the password 1255 for initialization.
After you enter the password and then touch the [ENT] key, all the
digits flash.
Touch the [ENT] key again to display "USr Go."
Touch the [ENT] key once more. All the digits then flash for two to
three seconds, and data initialization starts.
The initialization is complete, and the parameter code selection
display then appears.
IM 11M12A01-04E
11th Edition : Jul. 19, 2017-00
10-8