GE G60 Instruction Manual page 82

4.2 FACEPLATE INTERFACE
4. After the
CHANGE...PASSWORD
change the selection to "Yes".
5. Press the key and the display will prompt you to
6. Type in a numerical password (up to 10 characters) and press the
7. When the
VERIFY NEW PASSWORD
CHANGE SETTING
PASSWORD: No
4
CHANGE SETTING
PASSWORD: Yes
8. When the
NEW PASSWORD HAS BEEN STORED
active.
f) CHANGING EXISTING PASSWORD
To change an existing password, follow the instructions in the previous section with the following exception. A message will
prompt you to type in the existing password (for each security level) before a new password can be entered.
In the event that a password has been lost (forgotten), submit the corresponding Encrypted Password from the
menu to the Factory for decoding.
SECURITY
4-12
message appears on the display, press the VALUE
ENTER NEW PASSWORD
is displayed, re-type in the same password and press
ENTER NEW
PASSWORD: ##########
message appears, your new Setting (or Command) Password will be
G60 Generator Management Relay
4 HUMAN INTERFACES
CHANGE COMMAND
PASSWORD: No
CHANGE SETTING
PASSWORD: No
ENCRYPTED COMMAND
PASSWORD: ----------
ENCRYPTED SETTING
PASSWORD: ----------
key or the VALUE
.
key.
.
VERIFY NEW
PASSWORD: ##########
NEW PASSWORD
HAS BEEN STORED
key to
PASSWORD
GE Multilin