GE G60 Instruction Manual page 288
Generator management relay
Hide thumbs
Also See for G60:
- Instruction manual (780 pages) ,
- Communications manual (532 pages) ,
- Instruction manual (722 pages)
Table of Contents
Advertisement
7.1 COMMANDS
"
PATH: COMMANDS
COMMANDS CLEAR RECORDS
## COMMANDS
## CLEAR RECORDS
This menu contains commands for clearing historical data such as the Event Records. Data is cleared by changing a com-
mand setting to "Yes" and pressing the
"
PATH: COMMANDS
SET DATE AND TIME
## COMMANDS
## SET DATE AND TIME
The date and time can be entered here via the faceplate keypad only if the IRIG-B signal is not in use. The time setting is
based on the 24-hour clock. The complete date, as a minimum, must be entered to allow execution of this command. The
new time will take effect at the moment the
7
"
PATH: COMMANDS
RELAY MAINTENANCE
## COMMANDS
## RELAY MAINTENANCE
This menu contains commands for relay maintenance purposes. Commands are activated by changing a command setting
to "Yes" and pressing the
The
PERFORM LAMPTEST
command causes the relay to scan the backplane for the hardware modules and update the order code to
ORDER CODE
match. If an update occurs, the following message is shown.
There is no impact if there have been no changes to the hardware modules. When an update does not occur, the
message will be shown.
CODE NOT UPDATED
7-2
CLEAR USER FAULT
REPORTS? No
CLEAR EVENT RECORDS?
No
CLEAR OSCILLOGRAPHY?
No
CLEAR DATA LOGGER?
No
CLEAR ENERGY?
No
CLEAR UNAUTHORIZED
ACCESS? No
CLEAR DIRECT I/O
COUNTERS? No
CLEAR ALL RELAY
RECORDS? No
key. After clearing data, the command setting automatically reverts to "No".
SET DATE AND TIME:
2000/01/14 13:47:03
key is clicked.
PERFORM LAMPTEST?
No
UPDATE ORDER CODE?
No
key. The command setting will then automatically revert to "No".
command turns on all faceplate LEDs and display pixels for a short duration. The
UPDATING...
PLEASE WAIT
G60 Generator Management Relay
7 COMMANDS AND TARGETS
7.1.3 CLEAR RECORDS
Range: No, Yes
Range: No, Yes
Range: No, Yes
Range: No, Yes
Range: No, Yes
Range: No, Yes
Range: No, Yes
Valid only for units with Direct I/O module.
Range: No, Yes
7.1.4 SET DATE AND TIME
(YYYY/MM/DD HH:MM:SS)
7.1.5 RELAY MAINTENANCE
Range: No, Yes
Range: No, Yes
UPDATE
ORDER
GE Multilin
Advertisement
Table of Contents
