Virtual Outputs - GE G60 Instruction Manual

5 SETTINGS
Write the following FlexLogic™ equation (EnerVista UR Setup example shown):
Both timers (Timer 1 and Timer 2) should be set to 20 ms pickup and 0 ms dropout.
Program the Latching Outputs by making the following changes in the
!
PUTS CONTACT OUTPUT H1a
"
OUTPUT H1a OPERATE: VO1
" "
OUTPUT H1a RESET: VO4
Application Example 4:
A latching contact H1a is to be controlled from a single virtual output VO1. The contact should stay closed as long as VO1
is high, and should stay opened when VO1 is low. Program the relay as follows.
Write the following FlexLogic™ equation (EnerVista UR Setup example shown):
Program the Latching Outputs by making the following changes in the
!
PUTS CONTACT OUTPUT H1a
"
VO1
OUTPUT H1a OPERATE:
" "
VO2
OUTPUT H1a RESET:
!"
PATH: SETTINGS INPUTS/OUTPUTS
# VIRTUAL OUTPUT
1
#
MESSAGE
There are 64 virtual outputs that may be assigned via FlexLogic™. If not assigned, the output will be forced to 'OFF' (Logic
0). An ID may be assigned to each virtual output. Virtual outputs are resolved in each pass through the evaluation of the
FlexLogic™ equations. Any change of state of a virtual output can be logged as an event if programmed to do so.
For example, if Virtual Output 1 is the trip signal from FlexLogic™ and the trip relay is used to signal events, the settings
would be programmed as follows:
"Trip"
VIRTUAL OUTPUT 1 ID:
VIRTUAL OUTPUT 1 EVENTS:
GE Multilin
and menus (assuming an H4L module):
CONTACT OUTPUT H1c
"
OUTPUT H1c OPERATE:
OUTPUT H1c RESET:
menu (assuming an H4L module):
"
!"

VIRTUAL OUTPUTS

VIRTUAL OUTPUT
Virt Op 1
VIRTUAL OUTPUT
EVENTS: Disabled
"Disabled"
G60 Generator Management Relay
!"
SETTINGS INPUTS/OUTPUT
" "
VO2
" "
VO3
!"
SETTINGS INPUTS/OUTPUT
!
VIRTUAL OUTPUT 1(64)
Range: Up to 12 alphanumeric characters
1 ID
Range: Disabled, Enabled
1
5.7 INPUTS/OUTPUTS
!"
CONTACT OUT-
!"
CONTACT OUT-
5.7.4 VIRTUAL OUTPUTS
5-169
5