Installation; Configuration - Aastra OpenCom 510 User Manual

Voice over IP (VoIP)
The workplace computer requires a full-duplex-enabled sound card as well as a
suitable headset for audio recording and playback.
You will not need a licence to install OpenPhone IPC but you will require a licence
to operate it with the OpenCom 510. Unit licences, enabling the simultaneous
operation of a certain number of OpenPhone IPCs, are available.
The licences are activated in the OpenCom 510's Configurator in the Menu
SYS Configuration: Licences. The system software includes a licence for a demo
version for temporary use (60 days). Please contact your local agent or DeTeWe
representative if you wish to purchase a permanent licence. Licences can be com-
bined. Each licence can be activated only once.

10.5.1 Installation

Installation is done using a setup program. The OpenPhone IPC can also be
installed without a user interface. The program can then be used via a CTI appli-
cation (Net-TAPI or OpenCTI).
Start the installation program from the OpenPhone IPC product CD and follow the
installation assistant's instructions.

10.5.2 Configuration

Analogue to the VoIP system telephones, the OpenPhone IPC creates multiple IP
connections to the OpenCom 510. When you start the program for the first time,
the Options dialogue is automatically opened. Here you must configure the fol-
lowing values:
1. Enter in the VoIP IP Address field the OpenCom 510's IP address.
2. Enter six hexadecimal-digits into the Device ID field. This device ID is not a
MAC address, so overlapping with existent MAC addresses is possible. The
device ID is configured in the Configurator, on the PBX Configuration:
Devices: VoIP Phones page.
3. Confirm with OK.
128
OpenPhone IPC