Installation; Check For Completeness; Charging The Battery - Aastra DT690 User Manual

23

Installation

This section describes how to charge the battery, configure the headset or
use the belt clip.
23.1

Check for completeness

Make sure that all the parts are present. If anything is missing, please contact
your system administrator or supplier.
The set contains:
1. Cordless phone
2. Battery
3. Clip
4. Assembly card
Note:
23.2

Charging the Battery

The battery requires charging when
charge the battery:
•
The battery is fully charged within four hours.
The battery can be charged separately with a special battery charger.
1424-EN/LZT 103 090 Uen A1 2008-10-24
It is important to make a note of the IPEI code. The IPEI code may
be needed for unblocking the Cordless phone if an incorrect PIN code
has been entered three times. See Section 2.4 on page 10 for further
details.
Place the phone in the charger.
The battery is being charged when the indicator on the telephone is steady
orange. When the battery is fully charged the indicator will be green. A
flashing green indicator means incoming call or message. A red indicator
indicates battery warning. An animated battery icon is shown in the display,
indicating charging be starting with its current charge and ending with the
full charge. A filled battery icon indicates a fully charged battery.
in the display indicates low level. To
Installation
125