Licensing Information - Aastra OpenCom 510 User Manual

PBX Cascading
■
It is possible to operate an S
slave system. As the ISDN-L1reference clock signal supplied by an S
card is not precise enough, you will also need to operate an S
in the master system.
■
The slave system cannot be addressed directly through a LAN. For configu-
ration, always use the Web console of the master system.
■
A memory card installed in the slave system cannot be used.
■
To operate the slave system again normally, you must reset it to its factory set-
tings (refer to Resetting the System Data starting on page 97 and DIP Switch Set-
tings on page 135).
12.4

Licensing Information

A licence is required for certain additional OpenCom 510 program packages, for
example for the internal voice-mail system called OpenVoice.
The following information is for customers who have already obtained licences for
an OpenCom 510 and would like to cascade or network their existing system with
another OpenCom 510.
PBX Networking
If you network two OpenCom 510 systems with each other, you needn't generate
any new activation keys but can continue to use the corresponding functions on
the existing OpenCom 510. The "disadvantage" of this alternative is that you have
to administer a separate configuration on each OpenCom 510.
PBX Cascading
In the case of PBX cascading, the master system administers the overall configu-
ration.
If you have already installed activation keys on an existing OpenCom, they have to
be ported to the master system.
In this case, new activation keys for the use of additional program packages must
be generated on the DeTeWe licence server (http://lizenz.aastra-detewe.de). The
licensing confirmation for the cascading contains all the information you need to
carry out this procedure.
138
interface card of the type MS+S2M1-1 in the
2M
Licensing Information
interface
O
interface card
2M