Preconfiguration; Offline Configurator; Remote Configuration - Aastra OpenCom 510 User Manual

Configuration

8.2.5 Preconfiguration

Configuration of the OpenCom 510 can be prepared at your DeTeWe Customer
Service Centre or by an authorised DeTeWe dealer. For this purpose, a
OpenCom 510 installed here is programmed with the customer data (e.g. user
data, call distribution schemes, cord-bound terminals). This data is stored and then
loaded into the OpenCom 510 at the customer's site by a service technician.
This prepared configuration must be completed at the customer's site (LAN confi-
guration and DECT terminals).
For configuration of the OpenCom 510 Internet functions, first ask the responsible
system administrator for details of the customer's LAN prerequisites.

8.2.6 Offline Configurator

With the aid of the offline configurator a configuration for the system can be
issued and created on a Windows PC. Thereby most of the configuration points are
available. Each system type of the product family and firmware version release 7.0
or higher, has its own offline configurator; this is managed with the aid of a starter
program. The starter program is included on the product CD. The operating
systems Windows 2000 and XP are supported.
You can find further information in the chapter PC Offline Configuration starting on
page 170.

8.2.7 Remote Configuration

The OpenCom 510 configuration can also be altered or updated remotely by a cus-
tomer service centre or authorised dealer. This requires activation of internal RAS
access in the OpenCom 510 for the customer service centre/authorised dealer.
The customer service centre/authorised dealer can then log into the
OpenCom 510 as an administrator:
Note: If one or more MSNs are entered on the
PBX Configuration: System: Remote service menu page in
the Configurator and the Status option is activated, remote
configuration access is then activated when a data call from
one of the entered MSNs is registered.
Configuring the OpenCom 510
93