Factory Settings; Telephony Functions; Authorisations - Aastra OpenCom 510 User Manual

Factory Settings

2. Factory Settings
The OpenCom 510 is delivered with the following basic settings and activated fea-
tures. We recommend that you configure the OpenCom 510 to meet your specific
requirements before putting it into operation (see Configuration starting on
page 87).
Tip:
2.1

Telephony Functions

■
The OpenCom 510 is pre-configured for use in Germany.
■
Analogue terminals: The dialling mode (pulse dialling or DTMF) is detected
automatically.
■
Incoming external calls are signalled at all corded terminals connected to the
system.
■
The system PIN, which is used for remote-programmable call forwarding, for
example, is "0000".
2.2

Authorisations

Authorisations determine which functions can be used at the terminals connected
to the OpenCom 510. Authorisations are configured for so-called user groups;
users and their terminals are allocated to these groups.
Three user groups are preset: "Administrators", "Standard" and "Guests". "Adminis-
trators" have access to all functions of the OpenCom 510 and unrestricted configu-
ration rights. Users in the "Guests" group cannot configure the OpenCom 510, are
not able to make external calls, and have only restricted use of the terminal func-
tions of the OpenCom 510. The "Standard" user group, because of its default set-
tings, is well suited as a starting point for the creation of user groups for normal
users of the system (e.g. the staff members of a company).
14
Notes on the functions listed below can be found in the
glossary (provided as a PDF file on the system CD).
Telephony Functions