Aastra OpenCom 510 User Manual page 34

Installation
Ensure that the backplane plug of the interface card is securely plugged into
the socket on the backplane.
5. Refit the screws to secure the interface card in the 1-12 frame.
6. Plug the desired cables into the corresponding RJ45 sockets on the interface
card. Refer to Modules starting on page 61 for information on the pin assi-
gnment for each interface card.
7. Cover any unused slots with dummy covers (included in the scope of delivery).
The dummy covers must be securely screwed to the frame!
8. If you have exchanged the interface card, you will need to reactivate the slot for
this card.
Open the PBX Configuration: Ports: Slots page in the Configurator again. In
the table row listing the card that has been exchanged, click on Start.
9. Observe the LEDs on the card. Information on indicators can be found in the
chapter Modules starting on page 61.
Checking the Status of the Interface Cards via the Web Console
You can also check the status of the interface cards via the Web console of the
OpenCom 510.
1. Open the PBX Configuration: Ports: Slots page in the Configurator.
2. In the Status table row, check whether a green tick is displayed for the newly
installed interface card. The tick indicates that the interface card is operational.
32
Installing Modules