Connection To The Pu Connector - Mitsubishi Electric FR-E720-0.1K(SC) Instruction Manual

2.3.5

Connection to the PU connector

Using the PU connector, you can perform communication operation from the parameter unit (FR-PU07), enclosure surface
operation panel (FR-PA07) or a personal computer etc.
Refer to the figure below to open the PU connector cover.
PU connector
When connecting the parameter unit or enclosure surface operation panel using a connection cable
Use the optional FR-CB2
Insert the cable plugs securely into the PU connector of the inverter and the connection connector of the FR-PU07 or FR-
PA07 along the guide until the tabs snap into place.
FR-PA07
REMARKS
Overall wiring length when the parameter unit is connected: max. 20m
Refer to the following when fabricating the cable on the user side.
Examples of product available on the market (as of October 2008)
Product
1) 10BASE-T cable
2) RJ-45 connector
or connector and cable available on the market.
Parameter unit connection cable
(FR-CB2 )(option)
FR-PU07
Type
SGLPEV-T (Cat5e/300m)
×
24AWG 4P
5-554720-3
Control circuit specifications
To open the cover
Place a flathead screwdriver, etc. in a slot
and push up the cover to open.
PU connector
Maker
Mitsubishi Cable Industries, Ltd.
Tyco Electronics Corporation
2
33